DigiDesign D-show Manual page 86

To display Variable Group controls from the control surface:
Target an Input Channel or FX Return by pressing its Select
1
switch.
Do one of the following:
2
• Press the Stereo Pan switch in the ACS Bus Assigns sec-
tion.
• Press the F2 switch in the Function section.
The Stereo Pan and F2 switches flash to indicate display of
Variable Group controls.
Stereo Pan switch
Control surface switches for displaying Variable Groups
To change display back to Aux Sends, do one of the following:
Click the flashing Var Groups button on-screen.
– or –
Press the flashing Stereo Pan switch or F2 switch on the con-
trol surface.
Linking Aux Busses and Variable Group
Busses for Stereo Operation
When working with Aux busses or Variable Group busses, you
can link odd/even bus pairs and pan input signals into those
bus pairs. Aux bus pairs and Variable Group bus pairs are
linked on a global basis, and appear as linked on all channels.
To link Aux bus paris or Variable Group bus pairs:
Put D-Show into Config mode.
1
Go to the Options page and click the Busses tab.
2
Bus Pair
Links
Linking bus pairs in the Options > Busses page
Click Edit.
3
76 D-Show Guide
Click the checkboxes above any of the bus pairs to link or
4
unlink each pair.
F2 switch
Linking a Variable Group bus pair
Click Apply.
5
The checked Aux bus or Variable Group bus pairs appear as
linked on all channels.
When an Aux bus pair or Variable Group bus pair is linked,
the corresponding Stereo LED (marked "St") lights in the ACS
Aux Sends section.
With linked Aux bus or Variable Group bus pairs, the follow-
ing controls operate in tandem, affecting both sides of the bus
pair:
• Output faders
• Solo switches
• Mute switches
• Direct Output controls
• Delay Controls (Aux bus pairs only)
• Graphic EQ controls