DigiDesign D-show Manual page 211

PQ Link LED
PQ Link LED states
LED State Indicates
Green All PQ Controllers are
communicating cor-
rectly
Yellow, flashing At least one PQ Control-
ler cannot be found or
is not communicating
at all. Or, PQ Rack not is
not connected to a
Stage Rack.
Red, flashing Communication to at
least one PQ Controller
(or entire PQ Rack) has
been lost
If you power up with one less PQ Controller than before, the
LED will flash amber until explicitly shut off in Options > De-
vices.
To reconfigure D-Show after removing a PQ Controller:
Go to the Options page and click the Devices tab.
1
Right-click the offline unit and choose Forget.
2
Action
Check Options >
Devices to see if a PQ
Controller is still
listed that is no
longer in use or dis-
connected. Check all
other PQ cable con-
nections and power
status
Check power and all
cables
Chapter 27: Troubleshooting 201