DigiDesign D-show Manual page 219

Sidecar Back Panel
Sidecar back panel
Console Link In and Out Connectors
The Console Link In and Out connectors use 110-Ohm
AES/EBU (Digital) XLR cables to connect the Sidecar to the
Main Unit or to other Sidecars.
All Console Link connections require 110-Ohm AES/EBU
(Digital) cable. Do not use standard audio-grade micro-
phone cable to connect the Main Unit and Sidecars.
Termination Switch
The Termination switch is used to terminate the Console Link
chain. On the last Sidecar in a chain, this switch should be set
to "Terminate." On all other Sidecars, this switch should be
set to "Thru."
Console Link
In and Out connectors
Termination switch
I O
Power Switch
The Power switch applies power to the D-Show Sidecar.
AC Power Connector
The AC Power connector accepts a standard AC power cable.
The D-Show Sidecar is auto-power selecting (100V to 240V)
and automatically works with a standard modular power cord
when connected to an AC receptacle in any country.
Light Port
The powered light port supports an optional 3-pin XLR con-
sole light.
Chapter 28: Control Surface Reference 209
Light port
Power switch
AC power connector