DigiDesign D-show Manual page 67

Setting Input Gain
Gain can be controlled from individual channel strips or from
the ACS section.
Encoder 2
Assign
switches
Aux Assign
Flip
Input controls on input channel strips
+48V 20 dB Pad
Polarity Right Offset
Input Gain
Default LED
In/Out LED
Delay
HPF Freq
In/Out LED
HPF
Available
Pan
(Width)
Default
(Center) LED
Input controls and their location in the ACS
To adjust input gain for a channel:
Do one of the following:
1
• In the Encoder Assignment section, press the Gain switch
to assign gain control to the bottom row of rotary encod-
ers.
– or –
• Target the channel by pressing its Select switch. Gain
control for the channel is assigned to the Input Gain ro-
tary encoder in the ACS section.
Adjust the gain by turning the assigned rotary encoder.
2
To adjust input gain using the Gain Guess feature:
1
nel is receiving input signal. The LED flashes to indicate level
sampling.
2
Encoder 2
Setting Right Offset on Stereo Channels
On stereo Input Channels and FX Returns, the Gain control
Input meter
affects both the left and right channels. The Right Offset fea-
ture lets you offset the gain of the right channel relative to the
left channel by –20 dB to +20 dB, within the overall gain lim-
its.
Select
To adjust channel gain offset for a stereo channel:
Solo
1
ACS
2
KICK KICK
rotary encoder.
KICK KICK
Stereo Level Offset Indication
With stereo channels, if the difference in signal level between
Selected Channel
Solo and Mute the left and right channels is 12 dB or greater, the Stereo LED
below the channel meter flashes.
Pan
Pan adjusts channel pan (for mono Input Channels) and ste-
reo balance (for stereo Input Channels and FX Returns), allow-
ing you to control panning of signal to Groups or to Mains.
To adjust channel pan/balance:
1
2
tary encoder.
Press and hold the assigned rotary encoder while the chan-
Release the rotary encoder to the current gain guess.
When gain control is assigned to Encoder 2, you can press
encoders on multiple channels simultaneously to use Gain
Guess on each channel.
Do one of the following:
• In the Encoder Assignment section, press the Right Offset
switch to assign offset control to the bottom row of ro-
tary encoders.
– or –
• Target the channel by pressing its Select switch, then
press the Right Offset switch in the ACS Input section.
Channel Gain Offset is assigned to the Input Gain rotary
encoder in the ACS section.
Adjust the right channel gain offset by turning the assigned
Do one of the following:
• In the Encoder Assignment section, press the Pan switch
to assign pan/balance control to the bottom row of ro-
tary encoders.
– or –
• Target the channel by pressing its Select switch. Pan/bal-
ance control is assigned to the Width/Pan rotary encoder
in the ACS section.
Adjust the channel pan/balance by turning the assigned ro-
Chapter 7: Inputs and Input Routing 57