DigiDesign D-show Manual page 55

To change the Aux bus or Variable Group bus configuration:
Put D-Show in Config mode.
1
Go to the Options page and click the Busses tab.
2
Click Edit.
3
Configure the following settings:
4
• To link two mono Aux busses or Variable Group busses
into a bus pair, select the Link option for the correspond-
ing pair.
• Specify the panning for channels routed to Aux or Vari-
able Group bus pairs by selecting or deselecting the Fol-
lows Channel Pan option.
• Click to select the pickoff point for each bus (Pre-EQ,
Pre-Mute, or Pre-Fader).
Click Apply to reconfigure the system.
5
– or –
Click Cancel to exit without changing system settings.
Solo Operation
These settings customize Solo bus mode and operation.
See Chapter 14, "Solo and Monitor Busses."
Type Solo mode choices include PFL (Pre-Fader Listen), Stereo
AFL (After-Fader Listen), and Solo-In-Place.
Auxes/Var Groups Follow AFL Causes the controls for an Aux
Send or Variable Group Send to be automatically displayed on
the Input Channel encoders whenever the AFL switch is
pressed on the corresponding output bus.
Auto Cancel Soloing a channel strip automatically takes any
currently soloed channels out of solo.
Input Priority Makes soloed inputs temporarily replace soloed
output busses on the AFL/PFL bus.
Panning/Center Divergence
The Panning section provides control over center channel di-
vergence when the Main Bus is set to L–C–R mode. See "Main
Bus Center Divergence Options" on page 67.
To set Center Divergence:
Enter a value or drag in the Center Divergence text box and
press Enter.
Stereo Group Panning Operation
(Not Available in Variable Groups Mode)
The Stereo Group Panning Operation options provide differ-
ent levels of flexibility for how channels can be routed to
Groups.
See Chapter 9, "Groups."
To change Stereo Group Panning Operation:
Put D-Show in Config mode.
1
Click to select Simple or Expert mode.
2
Pickoffs
The Pickoffs page lets you control bus pickoff point on input
strips, as well as specify source and insert points for output
busses. The Pickoffs page also provides master control for
D-Show Delay Compensation.
Pickoffs tab of the Options page
Throughout this guide, Pickoff options are explained where
relevant.
Chapter 6: Options 45