DigiDesign D-show Manual page 119

Routing Oscillator Output
The output of the D-Show internal oscillator can be routed to
any of the output busses.
To route oscillator signal to any D-Show output bus:
Go to the Options page and click the Misc tab.
1
In the Oscillator section, select from the following signal
2
types:
• 100 Hz Sine
• 1 kHz Sine
• 10 kHz Sine
• Variable Sine
• Pink Noise
• White Noise
If you select Variable Sine, you can set the sine wave fre-
3
quency with the on-screen frequency control (directly to the
right of the Variable Sine option).
Oscillator controls in the Options > Misc page
Press the Oscillator switch in the Talkback/Osc section of
4
the Main Unit so that it is lit.
Press the Route to Selected switch. The switch flashes to in-
5
dicate Route to Selected mode.
Press the Select switch on each of the output busses (Auxes.
6
Groups, PQs, Matrixes, or Mains) where you want to route Os-
cillator signal. The Select switches flash to indicate Oscillator
assignment.
Press the flashing Route to Selected switch to confirm the as-
7
signment, or press the Cancel switch to cancel the assign-
ment.
Oscillator switch
Route To Selected switch
Level control
On/Talk switch
2-Track controls in the Talkback/Osc section of the Main Unit
Activating the Oscillator and Setting Level
To activate and set the level for the oscillator:
Press the Oscillator switch in the Talkback/Osc section so
1
that it is lit.
Activate the oscillator by doing any of the following:
2
• Press the On/Talk switch in the Talkback/Osc section.
• Click the on-screen "In" button in the Oscillator section
of the Options > Misc page.
Set the oscillator level by doing any of the following:
3
• Turn the Level knob in the Talkback/Osc section.
• Drag the on-screen Level knob in the Oscillator section of
the Options > Misc page.
Chapter 14: Solo and Monitor Busses 109