DigiDesign D-show Manual page 138

To adjust EQ parameters from the ACS:
Target a channel by pressing its Select switch.
1
Press the EQ In switch to enable built-in EQ on that chan-
2
nel. (The EQ In switch is provided in the ACS as well as in each
input fader strip.)
Adjust the appropriate EQ encoder.
3
Hi
Gain (rotate) and Band In/Out (press)
Q (digital mode)
Frequency (rotate) and Bell/Shelf (press)
Hi-Mid
Gain (rotate) and Band In/Out (press)
Q (digital mode) or bandwidth (analog mode)
Frequency (rotate) and Bell/Shelf (press)
Lo-Mid
Gain (rotate) and Band In/Out (press)
Q (digital mode) or bandwidth (analog mode)
Frequency (rotate) and Bell/Shelf (press)
Lo
Gain (rotate) and Band In/Out (press)
Q (digital mode)
Frequency (rotate) and Bell/Shelf (press)
In/Out
Plug-In
EQ controls in the ACS
To reset an EQ parameter to its default value:
Hold the Default switch and adjust the control.
To reset the entire EQ section (all bands) on a channel:
Hold the Default switch and press the EQ In switch.
128 D-Show Guide
Software Screen EQ Controls
You can adjust the built-in EQ using dedicated on-screen but-
tons for band in/out and bell/shelf toggling.
The D-Show software screen also provides the EQ Graph dis-
play to adjust frequency and gain simultaneously.
In/Out
Q/Bandwidth
Bell/Shelf
Q
Q
Q/Bandwidth
Bell/Shelf
Presets
EQ controls in the software screen (4-band Input Channel EQ shown)
To adjust parametric EQ parameters on-screen:
Select a channel on-screen.
1
Click the EQ In switch to put the EQ in circuit.
2
Adjust the on-screen controls by doing any of the following:
3
• Turn an on-screen knob (Gain, Q/Bandwidth, or Fre-
quency) for each frequency band.
• Click to toggle any on-screen EQ switch (EQ in/out, band
in/out, or bell/shelf).
• Click a displayed value and type a new value.
• Drag up or down in a value display to increase or decrease
the value.
To reset an on-screen EQ parameter to its default value, do one
of the following:
Alt-click the control.
– or –
Right-click the control and choose Reset.
To reset the entire EQ section (all bands) on a channel:
Right-click anywhere in the EQ section on-screen (but not
directly on an encoder or button) and choose Reset EQ Sec-
tion.
Digital/Analog
Gain
Band in/out
Hi
Frequency
Gain
Band in/out
Hi Mid
Frequency
Gain
Band in/out
Lo Mid
Frequency
Gain
Band in/out
Lo
Frequency