Table of Contents
Advertisement
Measured point height is above line start point's
height.
The height of the line start point is always
used as the reference height!
Layout
Here you can search or enter points for staking out
related to the measured line.
[ShiftLn]
Allows you to enter values for
shifting the line.
[AsBUILT]
Switches to AsBuilt-mode.
Programs
The graphics show you the position of the prism
related to the stake out point. Below, the exact
values are displayed, combined with arrows to show
the direction.
Line is positive (arrow up):
Target point is further away than the measured
point.
Offset is positive (arrow right):
Target point is right of the measured point.
Height is positive (arrow up):
Target point is higher than the measured point.
The height of the line start point is always
used as the reference height!
The graphics are scaled to give a better
overview. Therefore it's possible that the station
point moves in the graphics.
Be aware that the line start point and the line
end point are measured in the previous coordinate
system. When staking out this points they appear in
the old system and appear as shifted.
81
TPS400-5.0.1en
Advertisement
Table of Contents
