Table of Contents
Advertisement
Orientation coordinates can be either obtained from
the internal memory or entered manually.
The workflow is similar to Free Station workflow.
After each measurement you are asked wether to
proceed or not. Answering with yes brings you back
to the Measurement dialog, to take an additional
measurement. Answering with no brings you to the
Result dialog.
[COMPUTE]
Calculates and displays the orienta-
tion results.
[NextPt]
Input another backsight point.
1/I
Status indication; shows that first point was
measured in telescope position I.
1/I II
First point measured in telescope pos. I and
II.
Hz:
After the first measurement the finding of
other target points (or the same point when
changing the telescope position) is easier
by setting the indicated angle difference
near to 0°00'00" by turning the instrument.
Programs
: Difference between horizontal distance to
target point computed from coordinates and
the measured distance.
Display of computed orientation
[OK]
Set computed Hz-orientation.
If more than one target point is measured then the
orientation is computed using the "least squares
method".
53
TPS400-5.0.1en
Advertisement
Table of Contents
