Leica TPS400 Series User Manual page 55

Useful information
• If the orientation is only measured in telescope
position II the Hz-orientation is based on tele-
scope position II. If measured only in telescope
position I or mixed the Hz-orientation is based
on telescope position I.
• The prism height may not be changed during
measurements in the first and second telescope
position.
• If a target point is measured several times in the
same telescope position the last valid measure-
ment is used for the computation.
If no orientation was set and an application
was started resp. if in "Meas & Rec" [ALL] or [REC]
was triggered, then the current Hz-direction and V-
angle are set as orientation.
Programs
55
TPS400-5.0.1en