Restarting The Phone; Setting Or Changing The Signaling Protocol - Avaya J169 Installing And Administering

Initial setup and connectivity

Restarting the phone

About this task
Use the following procedure to restart the phone.
Procedure
1. Select RESTART PHONE from the Craft Procedures screen. The phone displays the
following text:
Press Restart to confirm.
2. Press Cancel to return to the Craft Procedures screen without restarting the phone.
Press Restart to proceed with the registration steps.
A restart does not affect user-specified data and settings like Contacts data or the phone
login and password.
The completion of the restart procedure depends on the status of the boot and application
files.

Setting or changing the signaling protocol

About this task
Use the following procedure to set or change the Signaling Protocol Identifier. A valid SIG Protocol
Identifier is either 0 (default), 1 (H.323), or 2 (SIP).
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
Procedure
1. Select SIG from the Craft Local Procedures screen. The deskphone prompts you to use
the Right and Left navigation arrows to select a setting and displays the following text:
Sig: text string
where the text string is the wording associated with the current system value of SIG,
defined as:
• Default when SIG = 0
• H.323 when SIG = 1
• SIP when SIG = 2
2. Press the Right or Left navigation arrow to navigate through the settings to change the
setting.
May 2018
Choice Selector
Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
44