Disabling And Enabling Event Logging - Avaya J169 Installing And Administering

• 10 Mbps full when PHY1STAT = 3
• 100 Mbps half when PHY1STAT = 4
• 100 Mbps full when PHY1STAT = 5
• 1000 Mbps full when PHY1STAT = 6
The PHY2STAT text strings are:
• Disabled when PHY2STAT = 0
• Auto when PHY2STAT = 1
• 10 Mbps half when PHY2STAT = 2
• 10 Mbps full when PHY2STAT = 3
• 100 Mbps half when PHY2STAT = 4
• 100 Mbps full when PHY2STAT = 5
• 1000 Mbps full when PHY2STAT = 6
2. To change the Ethernet setting, press the Right navigation arrow to navigate through the
possible settings.
Depending on the current value, the next sequential text string is selected and displayed
as the setting. For example, if the current value is 10 Mbps half (2) and if you press the
Right navigation arrow, the value changes to 10 Mbps full (3). If the current value is 1000
Mbps full (6) and if you press the right navigation arrow, the value changes to Auto (1).
3. To change the PC Ethernet setting, select that line and press the Right navigation arrow to
navigate through the possible settings.
4. Press Save to store the new settings and redisplay theCraft Procedures screen.

Disabling and enabling event logging

About this task
Use the following procedure to enable or disable logging of system events.
Procedure
1. When you select LOG from the Craft Local Procedure Screen, the deskphone prompts you
to use the Right and Left navigation arrows to select a setting and displays the following
text:
Log: text string
where the text string is the wording associated with the current system value of
NVLOGSTAT, defined as:
• Disabled when NVLOGSTAT = 0
May 2018 Installing and Administering Avaya J169/J179 IP Phone H.323
Comments on this document? infodev@avaya.com
Using local Administrative Menu procedures
Choice Selector
41