CEA DIGITECH vision PULSE 3200 Operator's Manual page 64

Software
ROBOT INTERFACE SW. VERS.
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
H02-01.00
F06-01.01
S/N
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
FX00204904080100
NETWORK BRIDGE SOFTWARE
VERSION
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
NETWORK BRIDGE SOFTWARE VERSION
TNI-300415-BETA-0003
DID0 10040204
DID1 106F402E
DC0 017F007F
A diagnostics menu can also be accessed by holding down the DX K
Software
DIAGNOSTICS MENU
DIAGNOSTICS
CAN BUS STATUS
I/O STATUS
REMOTE CONTROL
ENABLED OPTIONS
CAN BUS STATUS
CAN BUS STATUS
Rx packets
Tx packets
Rx FIFO0
Tx errors
Rx overruns
REC
TEC
REC max.
TEC max.
I/O STATUS
I/O STATUS
FAN
WATER COOLER PUMP
E0.3 UNDER VOLTAGE
E0.2 OVER VOLTAGE
E0.4 OVER CURRENT
T°C THERMAL PROTECTION
VRD
WATER COOLER PRESENCE
COOLING PLANT PRESSURE
REMOTE CONTROLS STATUS
REMOTE CONTROL
ANALOGIC INPUT 1
ANALOGIC INPUT 2
ANALOGIC INPUT 3
ANALOGIC INPUT 4
TORCH TRIGGER INPUT
UP TRIGGER INPUT
DOWN TRIGGER INPUT
AUX-IN
This indicates the software version loaded in the robot interface board, if applicable.
This indicates the serial number for the microprocessor contained in the digital interface
board. This is the serial number required for loading special functions at additional cost.
This indicates the network interface software version loaded in the board. There are also
identity codes that are only required for assistance, and can be requested if the network
malfunctions.
This menu has 4 diagnostics windows:
• CAN BUS STATUS
• I/O STATUS
• REMOTE CONTROLS STATUS
• ENABLED OPTIONS
Number of packages transmitted and received (Rx.. and TX..) and the number of
transmission errors.
98288
59392
98290
0
0
0
0
0
0
The status of the inputs and outputs on the generator.
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
The status of the inputs:
• ANALOGUE INPUT 1 (synergic remote control input)
• ANALOGUE INPUT 2 (arc length remote control input)
• ANALOGUE INPUTS 3 & 4 not connected
0
• TORCH BUTTON
0
0
• UP AND DOWN BUTTONS on the torch
0
OFF
• AUX-IN not connected
OFF
OFF
OFF
Description
and the DX K for three seconds.
EY EY
Descrizione
45
(continua)