Introduction; General Notes; Welding Machine Control Panel; Wire Feeder Control Panel (Not Used With Dh 32 And Vs 32) - CEA DIGITECH vision PULSE 3200 Operator's Manual

Introduction

This manual describes the functions of the software operating the following control panels:
• DH 32
• DH 33 + HT5
• DH 40 + HT5
• DH 50 + HT5
Functioning of the panels listed above is identical (the functions are the same but the characteristics differ depending on the type
of machine they are fitted on (e.g.: current regulation field).

General notes

• Any adjustments/changes made on the welder control panel are also displayed automatically on the drag-and-drop
control panel and vice versa, the images on the displays of both weld system components could however differ one
from the other, as the displays are consistent with adjustments/changes but also independent as far as visualization
is concerned.
• The adjustments / changes made are immediately available to the operator, unless indicated otherwise in the manual.

Welding machine control panel

The panel on the generator has four keys, two encoders, and a colour display. The figure below shows the panel. The figure be-
low shows the image of the panel.
ENCODER K

Wire feeder control panel (not used with DH 32 and VS 32)

The HT5 wire feeder panel has 2 keys, 2 encoders and 7 LEDs in the upper section and 4 keys and 5 LEDs in the lower section.
The figure below shows the panel. The figure below shows the image of the panel.
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
VS 32
VS 33 + HT5
VS 40 + HT5
VS 50 + HT5
MENU K
EY
SX K
EY
- SX
NOB
"DH" / "VS" CONTROL PANEL
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
"HT5" CONTROL PANEL
HOLD Function LED
PARAMETER DISPLAY S
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
ENCODER K
GAS K
SPECIAL FUNCTIONS (F
SPECIAL FUNCTIONS (F
4
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
- V
CREEN
- V
EY
- V
NOB
EY
) K
X EY
) LED
X