WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION K
EY
ENCODER K
- V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F
) K
X
EY
3 - PRE-SETTING
WARNING: All the parameters saved within a JOB (including SPECIAL FUNCTIONS (Fx)) can be viewed but not edited!
MENU K
EY
SX K
EY
ENTER/MEM K
EY
DX K
EY
The LED unit indicates the welding mode saved in the JOB selected, which is coherent with
the VISION S
CREEN
Displays the JOB number also selected in the SEQUENCES or the value for the parameter
- V
indicated by the PARAMETER SELECTION LED - V.
Scrolls the active parameters in succession, based on the type of welding process saved in
- V
the JOB selected.
Used to scroll through the JOBS in the SEQUENCES as well.
Activates the flow of gas.
Used to access displaying of the SPECIAL FUNCTIONS (Fx) saved in the JOB selected.
"DH" / "VS" CONTROL PANEL
MENU K
EY
SX K
EY
MENU K
EY
SX K
EY
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
Scrolls the active parameters in succession, based on the type of welding process saved in
the JOB selected.
If held down for a period of about 3 consecutive seconds, this key allows the VISION S
load all the parameters for the JOB onto the screen (making them available to the operator).
Scrolls the active parameters in succession, based on the type of welding process saved in
the JOB selected.
.
V
m/min
11.1 33.3
013
mm
2.8
0
001
001
1011 - Welding sequence
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
29
JOB/SEQUENCES
ENTER/MEM K
EY
DX K
EY
VISION S
CREEN
ENTER/MEM K
EY
DX K
EY
VISION S
CREEN
to
CREEN
Need help?
Do you have a question about the DIGITECH vision PULSE 3200 and is the answer not in the manual?
Questions and answers