Error Condition - CEA DIGITECH vision PULSE 3200 Operator's Manual

Error condition

WARNING: Under normal conditions of use it is not possible to open the "ERROR LOG Menu" display since the alarm message
appears instantaneously on the VISION S
ble to weld!
As soon as the error message appears:
ENCODER K
SX K
EY
ENCODER K - SX
NOB
VISION S
CREEN
In the case of an Automatically reset error once the alarm condition has ended (reinstatement completed correctly), the weld-
ing plant is once again ready and the operator can recommence welding! The alarm state disappears and the VISION S
turns to precisely the same point at which it was operating previously.
PLEASE NOTE: After resetting has been completed, during normal operation of the machine, the VISION S
error signal to inform the operator of the event (
K
. WARNING: This only removes the visual error indication but not the history of what happened!
EY
In the case of NON automatically reset errors, to remove the alarm status and reinstate correct operation of the machine, the
welding plant must be switched off.
When it is switched on again, the machine will be working again and the operator can weld again!
PLEASE NOTE: If, when switching on, the error status presents itself again, immediately contact's Technical Assis-
tance Department.
PARAMETER DISPLAY S
PARAMETER SELECTION LED - A
PARAMETER SELECTION K
WELDING MODE SELECTION K
WELDING MODE SELECTION LED
PARAMETER DISPLAY S
CREEN
PARAMETER DISPLAY S
CREEN
In the case of an Automatically reset error once the alarm condition has ended (reinstatement completed correctly), the weld-
ing plant is once again ready and the operator can recommence welding! The alarm state disappears and the VISION S
turns to precisely the same point at which it was operating previously.
as soon as the problem arises on the welding plant. At this stage it is not possi-
CREEN
"DH" / "VS" CONTROL PANEL
SX K
EY
- SX
NOB
If held down for a period of about 5 consecutive seconds it takes the VISION S
SETUP Menu.
Used to scroll the alarms activated.
Shows the alarm signal (
an indication of what happened (e.g. E.06 WATER COOLER MISSING) of the welding ma-
chine.
), but this can be removed visually from the display by simply pushing the MENU
"HT5" CONTROL PANEL (not used with DH 32 and VS 32)
- A
CREEN
- A
EY
ENCODER K - A
NOB
WIRE K
EY
EY
- A Displays the error message (e.g. Err.).
Shows the alarm code (e.g. E0.6) of in succession, the codes for the alarms in succession if
- V
there are a number of errors.
ERRORS 1
E0.6 WATER COOLER MISSING
), number of the errors that have occurred (e.g. ERRORS 1) and
34
VISION S
CREEN
CREEN
HOLD Function LED
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
GAS K
EY
SPECIAL FUNCTIONS (F ) K
X
SPECIAL FUNCTIONS (F ) LED
X
to the
CREEN
re-
CREEN
will still show the
- V
- V
EY
re-
CREEN