Replacing Joint (For Clamp) - Horizon Fitness APC-61 Manual

4-7 Replacing Joint (For Clamp)

Screw
Joint
Elbow
Pressure hydraulic
cylinder
Adjust-
ing
Screw
Elbow
Snap Ring
When joint can not be removed as follows, do
not remove forcibly but replace the whole
cylinder.
1. Remove parts up to plate according to "4-6
Replacing Clamp Link A, B, from the step 1
to 7".
2. Remove hose of hydraulic cylinder.
Elbow
Hydraulic Hose
Fix elbow with monkey wrench and loosen
the part of hydraulic hose pointed by the
arrow with wrench.
- Do not move the elbow. The elbow is fixed
after adjustment.
- When hose is removed, oil leaks from the
hose. Prepare something to clean.
4-13
3. Remove snap ring at the bottom of hydraulic
cylinder and remove cylinder from the
machine.
4. Remove joint.
Hydraulic
Cylinder
Cylinder Rod
Joint
Screw
Loosen screw, put a wrench in the part
pointed with the arrow, and hit joint counter-
clockwise by hammer.
5. Replace joint with a new one and fix by the
opposite order.
Grease the parts.
Put joint so that screw faces outside.
Screw