Adjustment Of Knife Lower Limit Position - Horizon Fitness APC-61 Manual

3-7 Adjustment of Knife Lower Limit Position

When replacing knife lower limit position
detecting sensor or the lower limit position of
new knife is shifted from dial scale "3" by 2
scales and over, the adjustment is needed to set
the lower limit position.
7mm Hexagon Head Bolt
Knife Lower Limit
Position Sensor
1. Loosen the 2 hexagon head bolts pointed by
the arrows and lift the bracket to the top.
Fix the bolts at this position.
View A
View A
2. Set cutting depth adjust dial to "3".
3. Remove the paper dust from the cutting stick
Cutting Depth Adjust Dial
4. Turn on the power switch and hydraulic
Knife Replacement
Position Detecting Sensor
5. Loosen the bolt and hit the head of dial to
Bracket
Knife Lower Limit
6. Repeat the step 4 and 5 until paper can be
Position Sensor
3-8
groove and set a new cutting stick.
pressure. Put a piece of 116gsm paper and
cut it. The sensor is lifted in step 1, that is
why a piece of paper will not be cut.
lower the bracket a little and fix it.
cut. Then fasten the bolts.