Replacing Limit Switches - Horizon Fitness APC-61 Manual

4-23 Replacing Limit Switches

To replace front limit detection limit switch
SW2 Front Limit Detection 1
SW3 Front Limit Detection 2
1. For easy operation, operate backgauge
backwards to the limit and turn power
switch of the machine off.
2. Pull out connector of the limit switch (=LS)
under back table. Remove and replace the
LS.
There are greased bolt and guide rail around
the LS.
To replace original detection limit switch
Table
1. For easy operation, operate backgauge
forwards and turn power switch off.
2. Pull out connector of the limit switch (=LS)
under back table. Remove and replace the
LS.
3. After replacement, turn power switch and
hydraulic pressure on and check cutting size
actually. If it is not correct, adjust according
to 3-1, 3-2, and 3-3 ÒAdjustment of Cut
SizeÓ.
Table
SW4 Original Detection
4-30
To replace backgauge adjust knob detection
limit switch
Table
SW1 Backgauge Adjust Knob Detection
1. Turn power switch off.
2. The limit switch (=LS) is under the table of
machine operation side. Pull out connector,
remove LS and replace.
There should be about 0.5mm gap with
backgauge adjust knob pressed.