Replacing Encoder - Horizon Fitness APC-61 Manual

4-11 Replacing Encoder

Back Cover A,B
Coupling
Stay
1 3
1. Remove back cover of the machine.
2. Loosen 4 screws 1 of coupling. (Allen
wrench 1.5mm)
3. Remove 2 screws 2 and pull out encoder
unit.
4. Loosen 3 screws 3 and remove encoder.
Encoder is a delicate part. Handle with care.
5. Replace encoder with a new one and fix
with screws 3 .
Encoder
6. Fix encoder by the opposite order.
2
7. Adjust according to 3-1, 3-2, and 3-3 "Ad-
justment of Cut Size" and fix screws 1 .
8. Fix back covers A and B.
Encoder
There are two different encoders depending
on S/N of the machine. But these are
interchangable each other.
4-18
Now one: E6B2-CWZ6C-100P/R
Old one: E6B-CWZ3C-100P/R
With the change of product numbers, the
coloring of cables is also changed depending
on the S/N of the machine. See the section
7-10 for wiring.
Terminal New
Power (+VCC) BRN
Output A phase BLK
Output B phase WHT
Output Z phase ORN
0V(COMMOM) BLU
GND Shield Shield
Old
RED
WHT
GRN
YEL
BLK