Right Angle Adjustment Of Backgauge To The Table - Horizon Fitness APC-61 Manual

3-11 Right Angle Adjustment of Backgauge to the Table

Backgauge is fixed as the gap between square
on the table and backgauge should be under
0.1mm. When the gap is not less than 0.1 mm
because of parts replacement or use for many
years, adjust as follows.
Less than 0.1mm
Square
Table
(The table itself also transforms strictly. Mea-
sure the gap when backgauge is at 500mm
position.)
1. Loosen lock lever.
2. Loosen lock nut for backgauge angle adjust
screw for a half turn.
3. Rotate backgauge angle adjust screw and
adjust the angle between backgauge and the
table.
(When the screw is fastened, back table
inclines forward.)
4. After adjustment, fasten lock nuts and lock
lever.
Backgauge
Backgauge Angle Adjust Screw
Lock Lever
Lock Nut
3-13
Gap
Table
- Check the gap with thickness gauge.
(Gap tends to be seen larger by eye
measurement.)
- Backgauge needs also parallelism to the
knife and the horizontality to the table.
Follow each chapter and adjust
simultaneously.