Replacing Clamp - Horizon Fitness APC-61 Manual

4-2 Replacing Clamp

WARNING
During this operation, hydraulic pres-
sure is turned on and off. If operated
with wrong order, the machine will be
heavily damaged or severe personal
injury will result to operator. Read care-
fully to the last procedure and under-
stand the contents well before operation.
[As preparation, operate as follows]
1. Remove knife according to operation
manual Ò6-2 Knife ReplacementÓ. This is
why it prevents you from severe personal
injury.
2. Remove rear table cover, rear cover R and
L.(See section 1-4.)
3. Pull up control box on the machine and fix it
with screw.
4. Remove right and left side gauges on rear
table.(See section 1-4.)
Control Box
Dumper
Clamp
Clamp Upper Limit
Position Detection Switch
5. Turn on the power switch and operate the
backgauge backwards to the limit.
6. Turn the hydraulic pressure switch on, set
Òknife operation mode select switchÓ to
ÒReplacing KnifeÓ, and turn cutting knife
ON/OFF switch up under the left side of the
table to operate clamp only.
7. Press the cut buttons. Only clamp lowers
and press the table.
8. Turn the hydraulic pressure and the power
switch off in this condition.
4-5
[Remove some parts around clamp]
9. Loosen 2 screws of dumper to remove it
dumper.
10. Remove the clamp upper limit position
detection switch from the bracket.
[Remove clamp connection parts]
Clip
Joint
11. Loosen the screws M6 at the bottoms of the
joints and pull out pins G. There is a hole of
5mm diameter for removal on pin G at
operation side. Hit the pins from this hole
with a thin stick.
Use a stick made from wood or aluminum. If
hit with steel, the end of pin is performed and
can not be fixed again.
M6
Pin G