Rough Adjustment Of Cut Size; Rough Adjustment Of Cut Size (Different Is About 0.5 Mm) - Horizon Fitness APC-61 Manual

3-3 Rough Adjustment of Cut Size (Different is about 0.5 mm)

When the position of the limit switch for
homeposition is shifted, the gap between dis-
play size and actual cut size occurs by 5mm.
View from here
Screw Shaft
Limit Switch for
Switch Bracket A
homeposition
1. Turn off the power switch.
2. Loosen the screws of switch bracket A.
(Screws is not necessary to remove.)
Screw
A
Switch Bracket A
3. Move this limit switch and fasten the
screws. (Limit switch is movable by 2mm
for- and backwards.)
When actual cut size is bigger than indicated
size: direction A
When actual cut size is smaller than indicated
size: direction B
3-4
4. Turn on the power switch and check the gap
between actual cut size and indicated size.
When there is a little gap, adjust according
to "3-2 Fine Adjustment of Cut Size Adjust-
ment of Cut Size (Difference is about be-
tween 0.1 and 0.2 mm)."
B