Backgauge Does Not Operate - Horizon Fitness APC-61 Manual

2-7 Backgauge Does Not Operate Part 2
Adjust knob remains pressed.
Adjust Knob
Spring
Snap Ring Bearing Unit
Backgauge adjust knob is normally pushed to
the operation side by spring. However, when
knob remains pressed for some reason, micro
switch turns on and the machine changes into
manual mode. Therefore, backgauge does not
operate.
When the adjust knob remains pressed and
does not return, check whether there is prob-
lem with snap ring, spring, and bearing.
Any of switches on operation panel remains
on.
(APC-M61)
APC-M61
HYDRULIC CUTTER
Power
Hydraulic
Micro Switch (APC-T61)
APC-T61
HYDRULIC CUTTER HYDRULIC CUTTER
For APC-M61:
Any of step forward button, size memory
button, and push-out memory button remains
pressed.
For APC-T61:
After button is pressed, it can be felt that the
button returns back with a sound.
Memory
Current Position Display
Presetting Program No. Step No. Replacing Knife
Step Forward Be sure to set "knife Angle
Adjustmant" knob and "Knife
Operation Mode" select
switch to each "Replacing
Knife"Position
Size
Step Memory
Cutting Operation & Knife
1 2 3 4 5 6 Vertical Adjustment
Be sure to set "knife
Operation Mode" select
switch to "cutting"
Push-out
position
Backgauge Travel
Memory
knife Operation
Mode
Program
Repeat / Setup Memory Delete
Forward Program Extension Replacing
Knife
Cutting
Put-out No More
Repeat Setup Memory Opar Error
Memory
? ?
Current position Presetting Program No. Step.No.
7 8 9
Program Memory
Replacing
4 5 6
knife
Delete
P + P -
ON
1 2 3
Push-out
.
S + S - 0 E
c
Setup
2-16
When any of the switches is out of order or
remains pressed, the machine determines
setting mode is operated. Therefore, backgauge
does not operate.
When the switch cap locks, return it to normal
condition. When the switch itself is out of
order, replace the board itself. (When replace-
ment of switch itself only is possible, replace
separately.)