Operation Panel Descriptions (M61) - Horizon Fitness APC-61 Manual

1-3 Operation Panel Descriptions (M61)

Current Position Display
This display shows the backgauge
current position.
Hydraulic Pressure Lamp
Power Lamp
Key Switch
Hydraulic Pressure ON Button
Hydraulic Pressure OFF Button
High Speed Backward Button
This button is used to move
backgauge backward at high
speed.
Low Speed Forward Button
This button is used to move backgauge
forward at low speed.
High Speed Forward Button
This button is used to move backgauge
forward at high speed.
Step Number Display
Program Number Display
Presetting Size Display
Current Position Display
APC-M61
HYDRULIC CUTTER
Power
Backgauge Travel
Hydraulic
1-7
Step Forward Button
Size Memory Button
Push-out Memory Button
Memory
Replacing Knife
Presetting Program No. Step No.
Be sure to set "knife Angle
Step Forward
Adjustmant" knob and "Knife
Operation Mode" select
switch to each "Replacing
Knife"Position
Size
Step Memory
Cutting Operation & Knife
Vertical Adjustment
1 2 3 4 5 6
Be sure to set "knife
Operation Mode" select
Knife Operation Mode Select Switch
switch to "cutting"
position
Push-out
Memory
knife Operation
This switch is used to replace knife.
Mode
Program
Replacing
Repeat / Setup Memory Delete Forward Program Extension
Knife
In normal operation, this switch must be set
Cutting
to the cutting mode.
Program Extension Button
Program Forward Button
Memory Delete Button
Repeat/Setup Select Button
In normal operation, this switch must be set to the
repeat mode. The above repeat/Setup Lamp lights up.
The size memory button must be set to the setup mode.
(The above setup Lamp lights up.)