Replacing Wearing Parts
This section explains how to maintain the PC-S43 to keep it in good condition.
1
Replacing the Cut Stick
When the groove in the cut stick gets too deep, the last few sheets may not be cut, or may not
separate completely. Rotate the cut stick or replace the stick.
WARNING
- Turn off the power switch
and key switch before chang-
ing or replacing the cutting
stick.
- Be careful not to touch the
knife above the stick.
Remove the cut stick
Turn off the power switch and key
switch.
Remove the cut stick
1) Insert the Allen wrench (supplied) into the cutout
and lift the cut stick by moving the wrench in the
direction shown by the arrow.
2) Remove the cut stick by prying up from the right
side to the left side.
Remove any dust in the groove.
Cut Stick
Allen Wrench
Install the cut stick
Install the cut stick.
One cut stick can provide eight working
lines on the four faces.
Cutout
(11)