Cut Size Is Not Equal Part 1 - Horizon Fitness APC-61 Manual

2-2 Cut Size Is Not Equal Part 2
24VDC is not output from power supply.
5
Power Supply PW-24
If output voltage of power supply PW-24 is
too low, the backgauge is delayed moving or
stop and the cumulative defference gets larger.
Check whether there is 24VDC output be-
tween 1 and 2 . Check whether there is
100VAC input between 4 and 5 . When there
is not 24VDC output in spite of 100VAC
input, replace power supply.
Gap of clutch or break is not correct.
4 3 2 1
PW-24 Gap of brake should be 0.15 to 0.30 mm.
Gap of clutch should be 0.2 to 0.3 mm.
When gap of brake or clutch is not in these
ranges, the time lag results in the motion of the
screw shaft. Therefore, defference between
the indicated size on the display and the actual
cut size results.
Adjust it to correct gap.
Or when there is foreign object such as metal
powder on friction surface, remove it with
compression air or wipe off with paper.
Operation Side
0.15 to 0.30
0.2 to 0.3
Clutch
Brake
2-7