Cut Size Is Not Accurate - Horizon Fitness PC-P430 Manual

2 Troubleshooting

2 - 7 Cut Size Is Not Accurate

Does the backgauge plate stick out?
Lever
6
4
No gap
7
3
1
3
■ The backgauge plate is pressed against the frame
by the spring. If there is a gap between the backgauge
plate and the frame, the cut size differs from the length
indicated by the indicator. If there is a gap, check the
following:
1
The three slide shafts are locked on the backgauge plate.
2
The two bearings are mounted correctly.
Nothing is between the backgauge plate
3
The bottom of the backgauge plate does not rub the
5
grooves on the back table .
6
The two knurled knobs are not loosened.
7
The spring is mounted correctly.
Is the indicator mounted correctly?
3
Not rubbing
the grooves
5
2
404018
2_7_1A
4 ■ Check that the indicator is mounted in the correct
position. If not, cut a sheet with the backgauge in that
position, and measure the length of the cut sheet.
Adjust the position of the indicator so that the indicator
indicates that length.
3 4
and the frame .
There is a gap between the indicator and the scale.
Therefore, the value changes if looked at from different
angles. Look straight down the indicator to read the value
correctly.
Cut Size Is Not Accurate
Indicator
404018
2_7_1B
See page 33 for details.
24
PC-P430