Cut Sheets Are Not Square - Horizon Fitness Horizon PC-45 Instruction Manual

5. Troubleshooting

5-1 Cut Sheets Are Not Square

(Cause)
Back gauge is not parallel to knife.
(Remedy)
Tools:
1. Wrench 5 mm
2. Wrench 4 mm
1.
Turn off power with key switch.
2.
Remove transparent cover in back gauge
section.
3.
Loosen back gauge fix screws and adjust
back gauge with adjust screw.
- Back gauge moves clockwise by loosen-
ing screw A and fastening screw B.
Length B is shortened by moving back
gauge clockwise.
4.
Fasten back gauge fix screw after adjust-
ing of back gauge.
5.
Turn on power and check that edges are
parallel by test cutting.
6.
Repeat procedure 1 to 4 until one edge
parallels another edge.
Length A and B is different.
A
Back Gauge Fix Screws
Fasten
Screw B
Loosen Screw A
Adjust Screw
Back Gauge Fix Screws
Loosen
Screw B
Fasten Screw A
Adjust Screw
22
B