YASKAWA YWE-EH500-6N0 Instruction Manual page 47

HW0480311
The following describes how to reset the system.
(1) Press the button
LED indicator
cator "Wire m/min" (WF) displays the parameter value lighting.
V
(2) Use the button
V
(3) Press the button
indicator "Wire m/min" blinks. Change the setting value of parameter "C23" to
"2004". When the setting value is four digits or more, use the button
the cursor to the 7-segment LED indicator
ter (A) displays the number(s) above the forth digit. The system reset will be exe-
cuted at C23=2004.
Wait until "sys rst" starts blinking.
V
(4) Turn OFF the welding source when "sys rst" is displayed. This is end of the initial-
ization.
V
(5) Turn ON the power supply and the parameters return to the default setting. Set the
recorded parameters again if necessary.
"Common PRM Select" during standby status. The 7-segment
voltmeter (V) displays "C.00" blinking, and the 7-segment LED indi-
A
13
"+", "-", "L" or "R" to display the parameter "C23".
A
11 "PRM Set", and the parameter value on the 7-segment LED
A
A
4-13
4.2 Settings on Welding Source Panel
Wire m/min
Wire m/min
ammeter (A). The indicator
Type
Wire m/min
Type
Wire m/min
HW0480311
Type
Type
13
"L" to move
amme-
47/129