YASKAWA YWE-EH500-6N0 Instruction Manual page 42

4.2 Settings on Welding Source Panel
indicator "Wire m/min" blinks. The set value of parameter is ready to be
changed. If the set value is four digits or more, use the button
cursor to the indicator
number(s) above the forth digit.
For changing the parameter number, press the button
The blinking digits move as shown below with each pressing of the button
Set".
(6) After changing the value, press the button
without doing anything for 10 seconds to return to the standby display.
Press the button
(conditions). Do not turn OFF the welding source during saving conditions. When
the 7-segment LED indicators are lit again, the saving of conditions is completed.
ammeter (A). The indicator
V
A
V A
14 "Record" for three seconds or more to save the changed values
4-8
13
ammeter (A) displays the
11
"PRM Set" again.
Type
Wire m/min
Type
Wire m/min
"Common PRM Select" or leave it
HW0480311
HW0480311
"L" to move the
11
"PRM
42/129