Changing Welding Type - YASKAWA YWE-EH500-6N0 Instruction Manual

4.2 Settings on Welding Source Panel
4.2
Settings on Welding Source Panel
4.2.1

Changing Welding Type

The following describes how to change the welding type.
(1) Press the button
blinks.
V
(2) Use the button
or "R" to move the digit.
(3) After changing the value, press the button
anything for 10 seconds, and the 7-segment LED indicator
V
Press the button
not turn OFF the welding source while pressing this button. The saving of condi-
tions is completed when the 7-segment LED indicators are lit again.
The welding types available for software version 3.20-000-6 (CPU) are listed on the
nameplate attached to the front panel of the welding source.
Welding types other than listed on the nameplate are not available. Using improper
welding type will result in unstable welding, which causes excessive spatters or
imperfect bead appearance. Before starting welding, confirm that the welding type
has been correctly selected.
12
"Weld. Type", and the 7-segment LED indicator
A
13
"+" or "-" to increase or decrease the value. Use the button
A
14
"Record" for 3 seconds or more to save the changed value. Do
4-4
Type
Wire m/min
"Weld. Type" or leave it without doing
12
"Type" lights.
Type
Wire m/min
HW0480311
HW0480311
"Type"
13
"L"
38/129