YASKAWA YWE-EH500-6N0 Instruction Manual page 10

Observe the following cautions to prevent personal injury by the end tip of the weld-
ing wire.
• Do not peep through the chip hole to confirm that the wire
is being fed.
If the wire is projected from the end tip of the welding torch, it may poke
you in the eyes or face.
• Do not bring the welding torch end close to eyes, face, or body to per-
form inching or pulling the torch switch.
If the wire is projected from the end tip of the welding torch, it may poke you in the eyes,
face, or body.
• When hanging the wire feeder, remove the anti-fall fastening
from the spool shaft and tighten.
Failure to observe this caution may cause the wire to
be removed from the spool shaft, resulting in personal injury.
Observe the following cautions to prevent burns due to the plasma arc.
If body parts such as hands and fingers directly touch the plasma arc,
burns will result.
• Do not put your hands and fingers near the chip and
the electrodes of the torch end during cutting operation.
• Do not grasp near the base metal during cutting operation.
• Turn OFF the power supply before replacing the chip or the electrodes
of the torch.
CAUTION
x
HW0480311
HW0480311
10/129