YASKAWA YWE-EH500-6N0 Instruction Manual page 17

HW0480311
Item
Voltage for Starting Point
Detecting Function
(Optional)
External Dimensions
[mm]
Mass
Welding Voltage Setting
Method
Arc Touch Start Function
User File
Adjustment of Voltage
and Current Waveform
Control
Interface for Robot Con-
troller
Output Setting Analog
Input
Error Output
Output for Arc
Monitoring
Power Supply of the
Heater for the Gas
Regulator
Standard Accessory
Remarks
±
Peak value: 220 V 20 % (full-wave rectification)
371 x 810 x 641 (width x depth x height)
(excluding the projections such as screws or eyebolts)
Approx. 70kg
Can be switched by "Auto Adjustment/Individual" (Synergic/Indepen-
dent) button on the welding source panel.
This function can be used by the parameters D2-2, D2-3, and D2-4.
Number of files: 3
"Panel" or "robot" can be switched by the parameter D1-11.
Can be changed by P parameters in the user file.
Refer to " 10 Robot Interface Signals ".
0 to 14 V (The set voltage, current, and wire feeding speed are displayed
on the welding source panel.)
Outputs the arc failure signal to the robot side. (Error contents are indi-
cated on the welding source panel.)
Outputs the signal corresponding to current or voltage to the robot side.
The output terminal stand for analog indicator is also available.
None
Fuse contained in glass tube of 5A (2 fuse)
Fuse contained in glass tube of 10 A (1 fuse) for Pr(SD)-006 board
Front panel: Written in English
1-2
Specifications
HW0480311
17/129