YASKAWA YWE-EH500-6N0 Instruction Manual page 115

HW0480311
6. Saving the conditions of calibration results
After confirming the calibration result, keep pressing the "Record" button for three sec-
onds or more to save the result.
7. Returning to the usual welding mode
Perform either of the following procedures to return to the usual welding mode.
• Press "PRM Select" button; or
• Turn OFF the welding source once and turn it ON again.
The welding after the welding current calibration is performed by the wire feeding
speed command which is calculated from the result of welding current calibration.
15.2 Procedure of Welding Current Calibration
15-5
HW0480311
115/129