Display Of External Resistance Setting Parameter - YASKAWA YWE-EH500-6N0 Instruction Manual

HW0480311
14.2.3

Display of External Resistance Setting Parameter

Press the "Weld.Type" button to end the external resistance measurement mode and returns
to the normal welding mode.
Confirm the measured external resistance value with the parameter C08 as follows:
(1) Press the "Common PRM Select" button to display the setting of common parame-
ters. Pressing the "+" button increases the displayed parameter number by one.
(2) Press the "+" button 8 times to confirm the measurement result with the parameter
C08.
PRM Select
Common PRM Select
Record
14.2.4
Setting the D Parameter for Calibration of External
Resistance to "Enabled"
To validate the calibration for the external resistance, the setting of D parameter is required.
1. Display the parameter that sets calibration for external resistance as follows:
(1) With the "Common PRM Select " button pressed, press the "PRM Select" button.
The setting of D parameter appears.
(2) Pressing of the "+" button once displays the parameter "d-2 1" that sets the external
resistance calibration to "Enabled" or "Disabled".
PRM Select
Common PRM Select
Record
14.2 Procedure of External Resistance Calibration
V Wire m/min
A
Press the "Common PRM Select" button to
set the mode to the C parameter setting mode.
PRM Set
Then, press "+" or "-" button to display "C.08"
A.W/S
on the 7-segment LED indicator.
L
Gas
Fig. 26 Display of the Set Parameter
V
Wire m/min
A
PRM Set
L
Press the "PRM Select" and "Common PRM Select" buttons
20
simultaneously to set the mode to the D parameter setting
Gas
mode.
Then press the "+" button to display the parameter "D-2 1".
Fig. 27 Display of D Parameter
14-6
Type
Power
Warning
Search
Weld,Type
File No.1
File No.2
R
File No.3
User File Select
Type
Power
Warning
Search
Weld, Type
File No.1
File No.2
R
File No.3
User File Select
HW0480311
109/129