Changing Common (C) Parameters - YASKAWA YWE-EH500-6N0 Instruction Manual

HW0480311
(5) Press the button
cator "Wire m/min" blinks. The set value of parameter is ready to be changed.
Change the set value in the range between 10 and 200 %.
For changing the parameter number, press the button
The blinking digits move as shown below with each pressing of the button
Set".
(6) After changing the value, press the button
anything for 10 seconds to return to the standby display.
Press the button
(conditions). Do not turn OFF the welding source during saving conditions. When
the 7-segment LED indicators are lit again, the saving of conditions is completed.
4.2.4

Changing Common (C) Parameters

For the details on the common parameter, refer to " 4.4 List of Common Parameters ".
The C parameter is the common parameters for the welding source.
Follow the instructions to change C parameter value as follows:
(1) Press the button
LED indicator
cator "Wire m/min" (WF) displays the parameter value lighting.
(2) Press the button
13
the button
move the blinking to the right.
(3) Using the button
(4) Use the button
(5) Press the button
"PRM Set", and the parameter value on the 7-segment LED indi-
11
V
A
V A
14 "Record" for three seconds or more to save the changed values
"Common PRM Select" during standby status. The 7-segment
voltmeter (V) displays "C.00" blinking, and the 7-segment LED indi-
13
"L" or "R" to change the number of blinking digits to one. Press
"L" to move the blinking to the left, and press the button
13
"L" or "R", move the blinking digits to the number to be changed.
13
"+" or "-" to increase or decrease the value.
"PRM Set", and the parameter value on the 7-segment LED
11
4-7
4.2 Settings on Welding Source Panel
11 "PRM Set" again.
Type
Wire m/min
Type
Wire m/min
"PRM Set" or leave it without doing
HW0480311
11
"PRM
13
"R" to
41/129