YASKAWA YWE-EH500-6N0 Instruction Manual page 36

4.1 Explanation of Welding Source Panel
The following table explains the display of the meters
The content of the display differs according to the status as follows:
Status
age Indicator
During When Displays the set
standb Parameter welding voltage
y C32=0, value (V).
Displays
Setting
Conditions.
When Displays 0.0V
Parameter
C32=1,
Displays
Stanby
During welding Displays the weld-
During wire inching ing voltage value
(V) that is fed-
back.
During setting param- Displays the
eter parameter num-
ber.
Display Lamps
Item Content
Power Lamp
Warning Lamp
Search Lamp
V
Welding Volt- Welding Cur-
rent Indicator
Displays the set
welding current
value (A).
Displays 0A
Displays the weld-
ing current value
(A) that is fed-
back.
Normally displays
"---". When the arc
touch start is
selected, displays
"-" in the parame-
ter P01.
Lights when the power supply is turned ON.
Lights or blinks when an error occurs. The error number is dis-
played on the digital meter.
Lights while the starting point detecting function is used. High
voltage is being generated while the lamp is turned ON. (Effec-
tive only when the starting point detecting unit is installed.)
4-2
, , , and
A Wire m/min
Wire Feeding
Speed Indicator
Displays the feed-
ing amount (m/
min) of the set
welding current
value.
Displays 0.0m/min
Displays the feed-
ing amount (m/
min) of the motor
that is fed-back, or
the motor current.
(Can be switched
by the parameter
D1-5.)
Displays
-P parameter:
ratio (%)
-C parameter:
value
(in decimal)
-D parameter
ON/OFF
Explanation
HW0480311
HW0480311
.
Type
Welding Type
Indicator
Displays the weld-
ing type (Type).
Displays the weld-
ing type (Type).
Displays the weld-
ing type (Type).
Displays the weld-
ing type (Type).
36/129