Table of Contents
Advertisement
Cleaning and care
Starting the descaling process
Select
Maintenance
Select
Descale
.
If the functions and Automatic
programmes that use moisture
injection are already disabled, the
descaling process can be started
immediately by touching OK.
Place the universal tray on the top
shelf level to collect the descaling
solution after it has been used.
Confirm the message shown with OK.
Place the container with the
descaling solution on the floor of the
oven.
Attach one end of the plastic tube to
the water intake pipe. Place the other
end of the plastic tube in the bottom
of the descaling solution container
and secure the plastic tube to the
container with the suction cup.
Confirm with OK.
The intake process will begin. You will
hear the noise of the pump.
The intake process can be interrupted
and restarted at any time by selecting
Stop
or
Start
.
108
.
The amount of descaling solution
specified can be more than the amount
which is actually taken in. Some of the
solution may therefore be left in the
container at the end of descaling.
A message will appear in the display
when the intake process is finished.
Confirm with OK.
The activation phase will begin. You
can follow the duration as it counts
down in the display.
Leave the container with the tube
connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in more
liquid during the activation phase.
The system will take in more liquid at
approximately 5-minute intervals. You
will hear the noise of the pump.
The oven lighting and the cooling fan
will remain on during descaling.
A buzzer will sound at the end of the
activation phase.
Advertisement
Table of Contents
