Miele H 7860 BPX Operating And Installation Instructions page 106

Hide thumbs Also See for H 7860 BPX:
Table of Contents

Advertisement

Cleaning and care
Finalising pyrolytic cleaning
When the remaining time has elapsed, a
message will appear in the display to
tell you that the door is unlocking.
will appear in the display and a
Finished
buzzer will sound as soon as the door
has been unlocked.
 Confirm the message shown with OK.
 Select
Close
.
 Switch the oven off.
The visual and acoustic signals will
switch off.
Risk of injury caused by hot
surfaces.
At the end of the pyrolytic cleaning
programme, the oven will still be very
hot. You could burn yourself on the
heating elements, the oven
compartment, or accessories.
Allow the heating elements, oven
compartment and accessories to
cool down before removing any
pyrolytic residues and before oiling
the shelf runners.
 Clean the oven compartment and
accessories suitable for pyrolytic
cleaning to remove any pyrolytic
residues (e.g. ash) that can build up
depending on the degree of soiling in
the oven compartment.
 Remove any residues from the cover
of the camera. You can use the
scouring pad on the back of a
dishwashing sponge.
 Add a few drops of heat-resistant
cooking oil to some paper towels and
use this to lubricate the shelf runners.
106
Most residues can be removed with
warm water, a little washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
Depending on the level of soiling, a
visible deposit can build up on the
glass on the inside of the oven door.
This can be removed with a
dishwashing sponge, a glass scraper
or a stainless steel spiral pad and a
little washing-up liquid.
The fibreglass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
Ideally, you should avoid cleaning it.
Enamelled surfaces can be
permanently discoloured by spilled
fruit juice. Such discolouration does
not affect the properties of the
enamel.
Do not attempt to remove these
marks.
Extending and retracting the FlexiClip
runners
After cleaning, discolouration or light
patches may remain on the FlexiClip
telescopic runners. This will not affect
the functionality in any way.
 Extend and retract the FlexiClip
telescopic runners several times after
running the pyrolytic cleaning
programme.

Advertisement

Table of Contents
loading

Table of Contents