To Change A Standby Or Heater Time - Nordson 3000V Series Manual

A 1-56
Installation
A3EN-04-[3V-A-AAXP]-12
To Set Standby and Heater Times
3. See Figure A 1-37. Press the Up key (6) below the Selector display
to select the day code (1) for which you want to set a time.
4. Press the Enter key (4) to save the day code setting. The Selector
display stops flashing and the hour (2) shown in the Multipurpose
display flashes.
5. Press the Up or Down keys (5) below the Multipurpose display until
the hour for which you want to set a time appears in the display.
6. Press the Enter key to save the hour setting. The hour shown in the
Multipurpose display stops flashing and the minutes flash.
7. Press the Up or Down keys until the minutes (3) for which you want to
set a time appear on the Multipurpose display.
8. Press the Enter key to save the minutes setting. All displays stop
flashing.
9. Record your setting in the forms provided at the end of this section.
Refer to Records of System Settings.
10. To set a second time for the same day, press the Move Right key until
the INTERVAL 2 light turns on. Press the Enter key to save the day
and repeat steps 5 through 9.

To Change a Standby or Heater Time

To change a set time, follow the procedure for setting the standby and
heater times.
41-3000V
Issued 5/00
(contd.)
E 2000 Nordson Corporation
All rights reserved