Programming Clock Controls; To Set The Clock - Nordson 3000V Series Manual

Programming CLOCK Controls

2
Fig. A 1-34 Selecting SET TIME
1. Move Up and Move Down keys
2. SET TIME light
E 2000 Nordson Corporation
All rights reserved
The seven-day clock feature turns the heaters on and off or takes the unit
into and out of the standby mode at preset times that you program. This
feature works in conjunction with the clock on the unit, which keeps the
correct day and time. It does not matter whether you set the current day
and time first, or set the standby and heater times. However, both
features must be set for the heaters to turn on and off correctly.
NOTE: If you experience a power outage, the unit's internal clock will
continue to keep time. Once power is restored and the unit is turned on,
the unit will resume normal operations. You do not need to reprogram
any features controlled by the clock.
NOTE: The clock does not automatically adjust for seasonal time shifts,
such as daylight savings time.

To Set the Clock

Follow this procedure to set the clock for the current time and day.
1
NOTE: The clock uses a seven-day, 24-hour format.
1. If you have not already done so, turn power on to the unit by pressing
the POWER switch.
2. See Figure A 1-34. In the System Setup area, press the Move Up
and Move Down keys (1) until the SET TIME light (2) turns on.
NOTE: If you have enabled the password feature, you must change
the number in the Multipurpose display (500) to the password (321)
and press the Enter key before the system will allow you to change
the clock settings.
4103934
41-3000V
Issued 5/00
A 1-51
Installation
A3EN-04-[3V-A-AAXP]-12