Programming A Pattern Set; Selecting An Output; Pattern Definition Lights - Nordson 3000V Series Manual

Programming a Pattern Set

1
4
PATTERN CONTROL
2
LINE
SPEED
STORE
USE
Fig. A 1-40

Selecting an Output

1. Move Up key
2. Move Down key
3. Move Right key
4. Output lights
E 2000 Nordson Corporation
All rights reserved
After you have defined the patterns for outputs 1 and 2, follow this
procedure to program the pattern set into the system.
1. See Figure A 1-40. In the System Setup area, press the Move Up (1)
or Move Down (2) key until the OUTPUT 1 or OUTPUT 2 light (4)
1
turns on.
2 NOTE: Outputs are limited to 1 amp per output or 2 amps total per
unit. Ensure that the guns connected to your unit do not exceed this
rating.
3
2. Press the Move Right key (See Figure A 1-40, item 3) until the light
for the bead start or end point you want to program turns on (begin
with the start point for the first bead). See Figure A 1-41.
4130224
Fig. A 1-41

Pattern Definition Lights

1. Light for start point for first bead
2. Light for end point for first bead
41-3000V
Issued 5/00
Installation
1 2 3 4
3. Light for start point for second
bead
4. Light for end point for second
bead
A3EN-04-[3V-A-AAXP]-12
A 1-63
4130223