Defining A Pattern Set; To Enter A Line Speed; Line Speed Settings For Units Of Distance - Nordson 3000V Series Manual

Defining a Pattern Set

1
PATTERN CONTROL
2
2
LINE
SPEED
STORE
USE
Fig. A 1-39 Selecting the Line Speed
Function
1. Move Down key
2. LINE SPEED light
If your unit displays
temperature in¼
Celsius degrees
Fahrenheit degrees
NOTE A: This is the unit of measure you will use in the next procedure, To Define a Pattern for Output 1 or
Output 2.
E 2000 Nordson Corporation
All rights reserved
Use this procedure to define a pattern set. To define a pattern set, you
must enter a line speed and define a pattern for each output (output 1
and output 2).

To Enter a Line Speed

1. See Figure A 1-39. In the System Setup area, press the Move Down
key (1) until the LINE SPEED light (2) turns on.
2. Check the Multipurpose display. The display shows the current
1
setting.
3. Press the Up or Down key below the Multipurpose display until the
display shows the line speed setting you want. Use the following
steps to determine your line speed setting:
a. If you plan to use units of time to define your patterns, set the line
speed to 0 and go to step 4. You must also use units of time in
the next procedure, To Define a Pattern for Output 1 or Output 2.
b. If you plan to use units of distance to define your patterns, refer to
Table A 3-17 to set your line speed, then go to step 4.
4130226
Table A 1-17 Line Speed Settings for Units of Distance
Determine your line
speed in¼
meters per minute (M/min)
feet per minute (ft/min)
4. Press the Enter key to accept the line speed setting. The
Multipurpose display stops flashing.
41-3000V
Issued 5/00
Use the following
setting for your line
speed:
a number from 1--150
a number from 1--500
A 1-61
Installation
Use this unit of measure
to define your patterns
(see Note A):
millimeters (mm)
inches (in.)
A3EN-04-[3V-A-AAXP]-12