Defaults For Bead Start And End Points - Nordson 3000V Series Manual

A 1-64
Installation
Programming a Pattern Set
(contd.)
A3EN-04-[3V-A-AAXP]-12
3. Check the Multipurpose display. The displays shows the default
setting for the bead start or end point. Refer to Table A 3-19.
Table A 1-19 Defaults for Bead Start and End Points
Start or End
Point Time (ms)
Start point for 50 ms
first bead
End point for 100 ms
first bead
Start point for 150 ms
second bead
End point for 200 ms
second bead
4. Press the Up or Down key below the Multipurpose display to change
the current setting. The display flashes.
5. Press the Enter key to save the new setting. The Multipurpose
display stops flashing.
6. Repeat steps 2--5 until you have programmed all bead start and end
points for the pattern.
7. If you have a second pattern to apply to your product, repeat
steps 1--6 to program the bead start and end points for the
second pattern.
8. Go to the next procedure, Storing a Pattern Set.
NOTE: Although the system will allow you to use a pattern set as
soon as you program it, it is best to define and store all the pattern
sets you will need. If you use a pattern set you have not stored and
then you later program a new pattern set, the system will replace the
pattern you were using with the new pattern as you program it into the
system.
41-3000V
Issued 5/00
Default Setting
Distance (mm) Distance (in.)
50 mm 5.0 in.
100 mm 10.0 in.
150 mm 15.0 in.
200 mm 20.0 in.
E 2000 Nordson Corporation
All rights reserved