Storing A Pattern Set - Nordson 3000V Series Manual

Storing a Pattern Set

1
PATTERN CONTROL
2
2
LINE
SPEED
STORE
USE
Fig. A 1-42 Selecting the Store
Function
1. Move Down key
2. STORE light
E 2000 Nordson Corporation
All rights reserved
After defining and programming a pattern set, you should store it so you
can use it any time you want. Refer to Using a Stored Pattern Set in the
Operation section of this manual. You can also replace an existing
pattern set with a new one. You can store up to 99 pattern sets.
1. If you have not already done so, program your pattern sets. Refer to
the preceding procedure, Programming a Pattern Set.
2. See Figure A 1-42. In the System Setup area, press the Move Down
1
key (1) until the STORE light (2) turns on.
3. Check the Multipurpose display. The display flashes the number of
the next available pattern set. For example, if you have already
stored three pattern sets in system memory, the Multipurpose display
will flash the number 4.
4130227
4. Determine whether you want to save the pattern set as a new pattern
set or whether you want to replace an existing pattern set.
To¼
Save the pattern set as a new
pattern set
Replace an existing pattern set
with a new pattern set
41-3000V
Issued 5/00
Installation
Do this¼
Press the Enter key. The
Multipurpose display stops
flashing.
A. Press the Up or Down key below
the Multipurpose display until the
number for the pattern set you
want to replace appears. The
Multipurpose display flashes.
B. Press the Enter key. The
Multipurpose display stops
flashing.
A3EN-04-[3V-A-AAXP]-12
A 1-65