Snmp Parameters - Polycom G7500 Reference Manual

SNMP Parameters

Topics:
▪ SNMP Parameters
This section describes available SNMP configuration parameters. Included are permitted values and, if
applicable, guidance for configuring related parameters.
SNMP Parameters
Use the following parameters to configure SNMP settings on your G7500 system.
snmp.enable
Allows administrators to monitor the system remotely using SNMP.
You must set this parameter to "1" to configure the other SNMP parameters.
0 (default)
1
snmp.notification.enabled
Enables MIB notifications.
0 (default)
1
snmp.version1.enable
Enables your system to use the SNMPv1 protocol.
Due to security issues, enabling this setting isn't recommended.
0 (default)
1
snmp.version2.enable
Enables your system to use the SNMPv2c protocol.
Due to security issues, enabling this setting isn't recommended.
0 (default)
1
snmp.version3.enable
Enables your system to use the SNMPv3 protocol.
1 (default)
0
snmp.community
Specifies the SNMP community string for your system.
Polycom, Inc. 82