Peripheral Device Parameters; Peripheral Device Pairing Parameters; Ip Microphone Parameters - Polycom G7500 Reference Manual

Peripheral Device Parameters

Topics:
▪

Peripheral Device Pairing Parameters

▪

IP Microphone Parameters

▪ Microphone Adapter Parameters
This section describes available peripheral device configuration parameters. Included are permitted
values and, if applicable, guidance for configuring related parameters.
These parameters apply to the following peripheral devices:
▪ Polycom IP Table Microphone
▪ Polycom IP Ceiling Microphone
▪ Polycom Microphone IP Adapter
Peripheral Device Pairing Parameters
Use the following parameter to automatically pair some peripheral devices with your G7500 system.
mr.primary.autoPair.enable
Enables your system to automatically pair with some peripheral devices, such as a Polycom IP
Table Microphone.
For example, if mr.primary.autoPair.enable="1" and you connect a table microphone to a LAN
port on your system, it should automatically pair and be ready to use.
1
0
IP Microphone Parameters
Use the following parameters to configure Polycom IP Table Microphones and Polycom IP Ceiling
Microphones connected to your system.
log.level.change.xxx
Controls the logging detail level. These are the input filters into the internal memory-based log
system.
Possible values for xxx are cfg, curl, mr, so, ss, ssps, and usb.
0-6 (default is 4)
log.render.level
Controls the logging level for the lowest severity of events to log in the syslog.
For example, when you choose a log level 0 or 1 - Severity Debug (7), the log includes all
events of an equal or greater severity level 0, this excludes events of a lower severity level 1.
2 or 3 - Severity Informational (6)
Polycom, Inc. 52