Polycom G7500 Reference Manual page 86

You must set snmp.version3.enable="1" to configure this parameter.
String (0-48)
snmp.engineID
Specifies the unique ID of the SNMPv3 engine. This might be needed for matching the
configuration of an SNMP console application. The ID is automatically generated, but you can
create your own as long as it is between 10 and 32 hexadecimal digits.
Each group of two hex digits can be separated by a colon character (:) to form a full 8-bit value.
A single hex digit delimited on each side with a colon is equivalent to the same hex digit with a
leading zero (therefore, :F: is equivalent to :0f:).
You must set snmp.version3.enable="1" to configure this parameter.
String
Must be between 10-32 hexadecimal digits.
Cannot be all zeros or Fs.
snmp.listeningPort
Specifies the port SNMP uses to listen for system messages.
Integer (1-65535)
161 (default)
snmp.transport
Specifies the transport protocol used.
UDP (default)
TCP
snmp.trapTarget.1.enable
Enable to send SNMP traps to an SNMP manager. You can send traps to up to three managers.
1 (default)
0
snmp.trapTarget.1.address
Specifies the IP address of an SNMP manager where SNMP traps are sent.
String (0-255)
snmp.trapTarget.1.messageType
Specifies the type of SNMP message.
Trap (default)
Inform
snmp.trapTarget.1.protocolVersion
Specifies the SNMP version used by the SNMP manager.
v3 (default)
v2c
v1
snmp.trapTarget.1.port
Polycom, Inc.
SNMP Parameters
84