Network Parameters - Polycom G7500 Reference Manual

Note: Setting device.net.secondaryNetwork.dns.server.* parameters is optional when
device.net.secondaryNetwork.mode="Manually".
When your system obtains these Wi-Fi properties automatically, you can't then overwrite individual
properties by setting device.net.secondaryNetwork.ipAddress="192.0.2.255", for example.
When provisioning a new IP address for your system, active sessions through the system web interface
don't automatically refresh. You must enter the new IP address in your browser to re-establish access.
Remember, to successfully provision any Wi-Fi setting, you must set
device.net.secondaryNetwork.type="WiFi".

Network Parameters

Use the following parameters to configure some network settings for your G7500 system.
device.net.dns.server.1
If the system does not automatically obtain a DNS server address on the wired LAN, enter one
here.
String
device.net.dns.server.2
(Optional) If the system does not automatically obtain a DNS server address on the wired LAN,
enter one here.
String
device.net.dns.server.3
(Optional) If the system does not automatically obtain a DNS server address on the wired LAN,
enter one here.
String
device.net.dns.server.4
(Optional) If the system does not automatically obtain a DNS server address on the wired LAN,
enter one here.
String
device.net.ipAddress
Specifies the system IPv4 address on the wired LAN.
You don't need to set this if device.net.mode="Automatically".
String
0.0.0.0
device.net.ipGateway
Specifies the IP gateway on the wired LAN.
You don't need to set this if device.net.mode="Automatically".
String
0.0.0.0
Polycom, Inc.
Network Parameters
42